Connecting Headphones; Auxiliary Input - Denon DSB-150 Manuel De L'utilisateur

E
N
G

Connecting Headphones

L
I
Connect the headphone plug to the 3.5mm jack beside the
S
internal speakers. If your headphones have a larger 1/4-inch plug you will need an adapter, available at
H
many retailers.

Auxiliary Input

Press the button on the top or on the remote control. The
the top will light blue.
The DSB-150 can accept an analog signal from a wide range of sources—
from CD players to MP3 players, and even older legacy devices. You'll need
a cable with a standard 3.5mm stereo mini plug to connect between the
source and the auxiliary input on the left side of the system.
Note: The analog output signals from some sources can be fairly strong. If the volume level of the
source device is turned up too high, it could overload the inputs of the DSB-150. This is unlikely to cause
damage, but can cause distorted sound. Initially, set the volume of the source to a medium – low level,
then turn it up as needed. If you hear distortion, turn down the device's volume control.
Wall Mounting the DSB-150
The DSB-150 can be wall mounted using the
keyhole openings on the back of the system.
Install two M5 or equivalent screws in the wall.
They must be exactly 3
level with each other. Leave about
of the screw shaft exposed so the head of the
screw can engage the keyhole opening. Carefully
position the DSB-150 keyhole openings over the
screw head and set it in place. Be sure the cabinet
is fi rmly mounted on the screw heads before you
let go of the system.
8
DSB-150E3 CD-ROM 140411_Final.indd
15 / " (100mm) apart, and
16
3 / " (5mm)
16
8
symbol. This turns off the DSB-150
button on
3 / in
15
16
(100mm)
2014/04/11 13:25:19