Denon DSB-150 Manuel De L'utilisateur page 7

3. The DSB-150 has two ways to initiate pairing:
NFC (Near Field Communication) or "tap-to-pair".
The newest and easiest pairing method. If you
have an NFC enabled device, simply place it
gently on the top of the DSB-150. Your phone
or tablet does the rest, and you can be playing
audio within seconds.
When the button on top lights solid blue, you are ready to go! Fire up your music and enjoy!
Once the DSB-150 is paired to a device, its Bluetooth address is stored in a 'Paired List' so it can hook up
to that device easily in the future. The DSB-150 is capable of storing up to 8 diff erent devices. Once that
limit is exceeded, the oldest device is cleared so that a new one can be stored.
After the fi rst pairing, the DSB-150 will automatically connect to your device when it is in range. The
button on top of the DSB-150 will light solid blue to indicate the system is ready to stream music from
your connected device. If a song is already playing through the device, the DSB-150 will start playing.
Note: If the Bluetooth button is lit, but nothing is heard:
1 Check the device to make sure a selection is playing. Make sure your music is not paused.
2 Check the device and the DSB-150 to make sure their volume levels are up and MUTE is not
enabled on either of them.
The DSB-150 will stay in pairing mode for up to 5 minutes, searching for a Bluetooth device (which must
also be in pairing mode). If it does not fi nd a device, the Bluetooth button will light red to indicate that it
was not able to pair. To try pairing again, press and release the
The button will begin to fl ash, indicating that the system is searching for a device with which to pair. If
you are still having trouble, try moving the device closer to the DSB-150 and repeat the pairing process.
DSB-150E3 CD-ROM 140411_Final.indd
Press and hold the button on the top of the
DSB-150, or on the remote, for 3 seconds. The
indicating that the system is looking for your
device.
Look at the Bluetooth list on your device. You
may have to select "search for devices" for a new
device to appear in the list of available devices.
Once "DSB-150" appears in that list, simply
select to pair.
7
button on the top will begin to fl ash blue,
3
seconds
button on the back of the DSB-150.
reset
E
N
G
L
I
S
H
3
seconds
7
2014/04/11 13:25:18