Safety And Operation Precautions - Ingersoll Rand VTR20 Manuel De Maintenance

SAFETY AND OPERATION PRECAUTIONS

_____________________________________________________________________________
Because an air compressor is a piece of machinery with moving and rotating parts, the same
precautions should be observed as with any piece of machinery of this type where carelessness
in operation or maintenance is hazardous to personnel. In addition to the many obvious safety
rules that should be followed with this type of machinery, the additional safety precautions listed
below must be observed:
1. Read all instructions completely before operating air compressor or unit.
2. For installation, follow all local electrical and safety codes, as well as the National Electrical
Code (NEC) and the Occupational Safety and Health Act (OSHA).
3. Electric motors must be securely and adequately grounded. This can be accomplished by
wiring with a grounded, metal-clad raceway system to the starter; by using a separate
ground wire connected to the bare metal of the motor frame; or other suitable means.
4. Protect the power cable from coming into contact with sharp objects. Do not kink power
cable and never allow the cable to come in contact with oil, grease, hot surfaces, or
chemicals.
5. Make certain that the power source conforms to the requirements of your equipment.
6. Pull main electrical disconnect switch and disconnect any separate control lines, if used,
before attempting to work or perform maintenance on the air compressor or unit. "Tag Out"
or "Lock Out" all power sources.
7. Do not attempt to remove any compressor parts without first relieving the entire system of
pressure.
8. Do not attempt to service any part while machine is in an operational mode.
9. Do not operate the compressor at pressures in excess of its rating.
10. Do not operate the compressor at speeds in excess of its rating.
11. Periodically check all safety devices for proper operation. Do not change pressure setting or
restrict operation in any way.
12. Be sure no tools, rags, or loose parts are left on the compressor or drive parts.
13. Do not use flammable solvents for cleaning the air inlet filter, element or any other parts.
14. Exercise cleanliness during maintenance and when making repairs. Keep dirt away from
parts by covering parts and exposed openings with clean cloth or Kraft paper.
15. Do not operate the compressor without guards, shields, and screens in place.
16. Do not install a shut-off valve in the discharge line unless a pressure relief valve of proper
design and size is installed in the line between the compressor unit and shut-off valve.
17. Do not operate compressor in areas where there is a possibility of ingesting flammable or
toxic fumes.
18. Be careful when touching the exterior of a recently run motor - it may be hot enough to be
painful or cause injury. With modern motors this condition is normal if operated at rated load
as modern motors are built to operate at higher temperatures.
19. Inspect unit daily to observe and correct any unsafe operating condition.
20. Do not "play around" with compressed air, nor direct air stream at body, because this can
cause injuries.
21. Compressed air from this machine must not, under any circumstances, be used for food
processing or breathing air without adequate downstream filters, purifiers, and controls.
22. Always use an air pressure regulating device at the point of use. Do not use air pressure
greater than marked maximum pressure of attachment.
23. Check hoses for weak or worn condition before each use, and make certain that all
connections are secure.
24. Always wear safety glasses when using a compressed air tool.
The user of any air compressor package manufactured by
failure to follow the preceding Safety and Operation Precautions can result in injuries or
equipment damage. Ingersoll Rand
preceding list of Safety and Operating Precautions is all inclusive, or further that the observance
of this list will prevent all injuries or equipment damage.
Ingersoll Rand
does not state as fact and does not mean to imply that the
IF3163 Rev A Page 4
is hereby warned that