Maintenance; Daily Maintenance; Troubleshooting; Error Codes - McCulloch Li 58HT Manuel D'utilisation

Note: The motor automatically stops if the battery pack
or motor controller is too hot during heavy operation. Let
WARNING: Read and understand the safety
chapter before you clean, repair or do
maintenance on the product.

Daily maintenance

• Remove the battery pack. Refer to the operating
instructions of the battery pack for correct

maintenance.

• Examine the nuts, screws and bolts.
• Examine the trigger for correct operation.
• Examine the power button for correct operation.
• Remove external unwanted material from the
product with a soft brush or dry cloth. Do not clean
with water, cleaning fluids, or solvents.
Problem Possible faults
The product The power is off.
does not start
No electrical contact between
the product and battery pack.
The battery pack is not charg-
ed.
The battery pack or product
are too hot.
The battery pack or product
are too cold.
Motor controller is too hot.
Blades do not Blades are blocked
move

Error codes

The error codes help you do troubleshooting on the
battery pack and/or the battery charger while it charges.
(Fig. 17 )
454 - 002 - 20.11.2017
the motor and battery pack cool. The product then
resets.
MAINTENANCE
•
•
•
•
•
•
•

TROUBLESHOOTING

Possible step
Start the power. See
Install the battery pack correctly. See
page 8 .
Charge the battery pack. See the operator's manual for the battery
pack.
Let the battery pack and product cool down before you start the
product.
Let the battery pack and product become warm before you start
the product.
Let the battery pack and product cool down for a minimum of 1
hour before you start the product.
Remove unwanted material
Note: Look at the battery state of charge LED with the
ribs of the battery pointed up to see the correct
orientation of the LED lights.
Use a soft brush to remove unwanted material from
the air vents.
Examine the product for missing, damaged, loose or
worn parts.
Examine the product to make sure the moving parts
align and are safe for operation.
Lubricate the blades to prevent corrosion. The
lubricant must not be poisonous or dangerous to
persons, animal or plants. Make sure that the
lubricant goes between the top and bottom blades.
Attach the blade guard.
Lock the product in an area that children and not
approved persons cannot access.
If the product is damaged, speak to an approved
service center. Do not use a damaged product.
To start the motor on page 8 .
To install the battery pack on
9