Philips SensoTouch 7000 Série Mode D'emploi page 12

ENGLISH
12 12
2 Insert the lug of the trimmer into the slot in the top of the shaver
(1). Then press down the trimmer (2) to attach it to the shaver
('click').
3 Press the on/off button once to switch on the trimmer.
RQ1180: The display lights up for a few seconds.
,
4 You can now start trimming.
5 Press the on/off button once to switch off the trimmer.
RQ1180: The display lights up for a few seconds to show the
,
remaining battery capacity.
6 Pull the trimmer straight off the shaver.
Note: Do not twist the trimming unit while you pull it off the shaver.
7 Insert the lug of the shaving unit into the slot in the top of the shaver
(1). Then press down the shaving unit (2) to attach it to the shaver
('click').
Using the Beard Styler attachment (RQ1195, RQ1175 only)
Note: Only use the Beard Styler attachment to trim facial hair (beard,
moustache and sideburns). Do not use it to trim body parts below the neckline.
1 Make sure the shaver is switched off.
2 Pull the shaving unit straight off the shaver.
Note: Do not twist the shaving unit while you pull it off the shaver.
3 Insert the lug of the Beard Styler attachment into the slot in the top
of the shaver (1). Then press down the Beard Styler attachment (2)
to attach it to the shaver ('click').
Using the Beard Styler attachment with comb
You can use the Beard Styler attachment with the comb attached to style
your beard at one fixed setting, but also at different length settings. The
hair length settings on the Beard Styler attachment correspond to the
remaining hair length after cutting and range from 1 to 5mm.