REPLACING THE LAMP
CLOSING THE DOOR
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to
"Installation".
TECHNICAL DATA
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in
the rating plate on the internal left side of
the appliance and in the energy label.
1.
Disconnect the mains plug from the
mains socket.
2.
Remove the screw from the lamp cov-
er.
3.
Remove the lamp cover (refer to the
illustration).
4.
Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household applian-
ces. (the maximum power is shown on
the lamp cover).
5.
Install the lamp cover.
6.
Tighten the screw to the lamp cover.
7.
Connect the mains plug to the mains
socket.
8.
Open the door. Make sure that the
lamp comes on.
3.
Height
Width
Depth
If necessary, replace the defective
door gaskets. Contact the Service
Center.
815 mm
596 mm
550 mm
13 h
230 V
50 Hz
ENGLISH
37