Project Commissioning - Ferroli TES FC 3V Manuel D'utilisation

10 Project Commissioning

10.1 Restore Factory Default Settings
● Touch and hold
controller will restart with its parameters restored to the factory settings.
10.2 Error Display
● When the sensor fails, the LCD displays the error code E1 in the
Temperature Setting display area;
● In the Parameter Settings interface, the LCD displays the
Modbus communication fails;
● Notify the distributor of the error code. Do not disassemble, modify or
repair the air conditioner without authorization.
10.3 Parameter Settings of the Temperature Controller
● Parameters can be set when the unit is on or off.
● Touch and hold
interface.
● After entering the page for parameter settings, C0 is displayed in the
temperature display zone. Press
Code; after selecting Parameter Code, press
parameter settings. Press
save the parameters. Press
parameters.
● If no operation is made in 60s, the page will save your parameters and
close.
● When it is in the parameter settings page, the wired controller cannot
communicate with Modbus.
, and at the same time for 5s, and the wired
and for 3s to enter the parameter settings
and
and
to exit the parameters without saving
08
to switch over to Parameter
to enter the specific
to set parameters. Press
icon when
to
EN