Setting The Sensitivity (Baby Unit Only) - Swissvoice Babycom 143 Mode D'emploi

Babycom 143
Set the CTSS codes using the microswitch (red) in the battery compart-
ment.
Use a pointed object (e.g. pencil) to set the codes.
Table of CTCSS Codes
CTCSS Codes
Code 1
Code 2
Code 3
Code 4

Setting the sensitivity (baby unit only)

Set the preferred sensitivity level by sliding the switch on the right of the
baby unit:
- Up: (HIGH) = high sensitivity (responds to noises within a range of 2-6
meters)
- Down: (NORMAL) = medium sensitivity (responds to noises within a
range of 1-2 meters)
Switch 1
On
On
Off
Off
Switch 2
On
Off
On
Off
48