Settings; On/Off; Setting The Volume; Setting The Channel - Swissvoice Babycom 143 Mode D'emploi

Settings

On/off

- To switch the units on: Press and hold the Power key for approx. 2
seconds. An acknowledgement signal (2 short beeps) is emitted and
the power display lights up (green = batteries charged).
- To switch the units off: Press and hold the Power key for approx. 2
seconds. An acknowledgement signal (1 short beep) is emitted and
the unit is switched off.

Setting the volume

Use the VOL+/VOL- keys to set the preferred volume. You have the
choice of 3 volumes. A control signal to check the set volume is emitted
when the device receives a signal.

Setting the channel

Use the channel switch on the left of the parental/baby unit to set the
preferred channel (Channel 1 or 2).
Note:
The parental and baby unit must be set to the same channel in order to
interconnect the units!

Setting the CTCSS code

Four CTCSS subchannels are available for a protected private sphere:
The receiver (parental unit) is activated only when it receives a signal
from its own transmitter (baby unit). It is therefore essential for the same
CTSS code to be set on the parental and baby unit so that they can
communicate.
Babycom 143
47