Charging The Batteries Initially / Connecting The Adapter; Colour Codes For Power Display - Swissvoice Babycom 143 Mode D'emploi

Babycom 143

Charging the batteries initially / connecting the adapter

- Before using the device for the first time, the batteries need to be
charged.
- To charge the batteries, plug the adapter into the AC/DC sockets on
the parental and baby units.
- Plug the adapter into an electrical socket. The batteries will then start
to charge up and will take around 8 hours to fully charge (initially).
Note:
- The adapters supplied were developed specifically for this device. Do
not use them for any other device. Never use another adapter for your
Babycom 143.
- Non-rechargeable batteries must not be charged up.
- We recommend that you switch off the units before plugging in or
unplugging the adapters.
- If the units are not to be used for some time, unplug the adapters.

Colour codes for power display

Power supply
Battery operation
(batteries weak)
Battery operation
(batteries full)
Out of range
Device OFF
Device ON
Red
X (flashing)
X ( flashing)
Flashing intermittently
Green Amber
X
X
44