Installing The Mounting Bracket - Fanaway Evora Mode D'emploi

Fanaway Evora Installation Instructions
1 Mounting bracket x 1
2 Canopy screws x 4
3 Canopy x 1
4 Down rod x 1
5 Bolt & pin cover x 1
6 Bolt x 1
7 Pin x 1
8 Top housing x 1

The ceiling fan must be installed in a location so that the blades are a minimum 300mm spacing from
the tip of the blade to the nearest objects or walls.

Secure the hanging bracket to the ceiling joist or structure that is capable of carrying a load of at least
30kg, with the two long screws provided. Ensure at least 30mm of the screw is threaded into the
support.
NOTE: The bracket screws provided are for use with wooden structures only. For structures
other than wood, the appropriate screw type MUST be used.
Angled Ceiling Installation
This fan hanging system supports a maximum 15 degree angled
ceiling installation.
6 | P a g e

INSTALLING THE MOUNTING BRACKET

Fig. 3
9 Blades x 4
10 Retraction mechanism x 1
11 Lamp base x 1
12 Cover x 1
13 Screws for cover x 3
14 Lamp shade x 1
15 Wood screws x 2
16 Remote receiver x 1
17 Remote hand set x 1
Fig. 2