What To Do If - IKE OMNEJD Mode D'emploi

ENGLISH
What to do if ...
Problem
The appliance does not work
The hood's suction level is not
enough
The light does not work
Before contacting the After-sales service:
Switch the appliance on again to see if the
problem has disappeared. If not, switch it
off again and repeat the operation after an
hour.
If your appliance still does not work
properly after carrying out the checks listed
in the troubleshooting guide and switching
the appliance on again, contact the After-
sales service, clearly explaining the problem
and specifying:
Possible cause
There is no mains
electrical power
The appliance is not
connected to the
electrical supply
The suction speed is too
low
The metal filters are
dirty
The air vents are
obstructed
The light bulb is broken
The light bulb is not
correctly fitted
• the type of fault;
• the model;
• the type and serial number of the
appliance (given on the rating plate);
• the Service number (the number after the
word SERVICE on the rating plate inside the
appliance).
Solution
Check for the presence of
mains electrical power.
Turn off the appliance and
restart it to see if the faults
persists.
Check if the appliance is
connected to the electrical
supply.
Turn off the appliance and
restart it to see if the faults
persists.
Check the suction speed and
adjust as necessary.
Check that the filters are clean
If not, clean the filters in the
dishwasher.
Check the air vents for any
obstructions and remove as
necessary.
Check the light bulb and
replace it if necessary.
Check that the light bulb has
been correctly fitted.
If not, fit the light bulb in right
way.
10