Care And Maintenance; Maintenance Instructions; Maintenance Schedule - Kärcher WPD 100 Basic Mode D'emploi

Maintenance instructions

WARNING
Health hazards on account of improperly maintained
device. The device may only be maintained by trained
and skilled personnel.
Use only original parts of the manufacturer or part sug-
gested by him, such as
– parts and wearing parts,
– accessories parts,
– operating materials,
– cleaning agents.
Before doing any work on the machine:
 Set the appliance switch to "0".
 Pull out the mains plug.
 Shut off water supply.
Maintenance contract
In order to ensure a reliable operation of the device, we
recommend that you conclude a maintenance contract.
Please contact your competent KÄRCHER service.
Time
daily
weekly, more frequently if necessary
Quarterly
half-yearly
annually *
The changing intervals of the filter apply to the defined test conditions and can deviate from the indicated times.
Cleaning inlet sieve
 Shut off water supply to the appliance.
 Press the button for unchilled water briefly in order
to reduce the water pressure in the device.
 Remove the water inlet hose on the appliance.
 Pull out the inlet sieve using needlenose pliers.
 Clean inlet sieve.
 Insert the inlet sieve into the device.
 Connect the water supply hose to the water con-
nection on the rear of unit.
 Open the water supply.

Care and maintenance

Maintenance schedule

Performance
Clean the drip pan and the water output with disinfecting detergent (RM735, see consumables).
Check the drip pan drain (option) for obstructions.
If the device was not used overnight, dispense and pour away 0.5 l of each water type.
Clean the outside surfaces of the appliance with disinfecting detergent. Clean the drip pan with hot water or in the dishwasher.
Do not use detergents that contain alcohol, acidic ingredients or scouring agents for cleaning plastic surfaces.
Empty can.
Check can for cleanliness and clean or replace if required.
Check and clean the inlet sieve in the water connection (see "Care and maintenance/cleaning inlet sieve").
Clean the inlet sieve on a monthly basis in case of heavy soiling.
Perform the chemical cleaning operation.
Replace the UV lamp.
Have annual customer service work performed.
Replace the Active-Pure and Hy-Protect filter.
Replace Hy-Pure filter.
EN
Note:
The base and all components shown are optionally
available.
1 Base
2 Drain hose drip pan
3 Pressure reducer
4 Can lid
5 Can
6 CO
7 Additional cooler (WPD 600 only)
5
-
bottle
2
19