Using Sensor Settings; Covering Foods; Sensor Popcorn / Sensor Reheat - hestan KMWR30 Manuel D'utilisation Et D'entretien

DRAWER MICROWAVE COOKING
SENSOR SETTINGS SENSOR SETTINGS
Hestan's Sensor is a semi-conductor device that detects the vapor (moisture and humidity) emitted
EN
from the food as it heats. The sensor adjusts the cooking times and power levels for various foods and
quantities.

USING SENSOR SETTINGS:

USING SENSOR SETTINGS:
• After the Drawer Microwave is plugged in, wait 2 minutes before using any sensor setting.
• Be sure the exterior of the cooking container and the interior of the Drawer Microwave are dry.
Wipe off any moisture with a dry cloth or paper towel.
• The sensor works with foods at normal storage temperature. For example, popcorn would be at
room temperature.
• Any sensor selection can be programmed with MORE OR LESS TIME ADJUSTMENT. See
page 21.
• More or less food than the quantity listed in the charts should be cooked following the guidelines
in any microwave cookbook.
• During the first part of sensor use, the food name will appear on the display. Do not open the
Drawer Microwave or touch
vapor will be interrupted. If this occurs, an error message will appear. To continue cooking, touch
the
STOP/CLEAR
When the sensor detects the vapor emitted from the food, the remainder of cooking/reheating
time will appear. The Drawer Microwave may be opened when the remaining time appears on the
display. At this time, you may stir or season food, as desired.
• Except for Popcorn, if the sensor does not detect vapor properly when cooking other foods,
ERROR
• Check food temperature after cooking. If additional time is needed, continue to cook manually.
• Each food has a cooking hint. Touch the
the display.

COVERING FOODS:

COVERING FOODS:
Some foods work best when covered. Use the cover recommended in the charts for these foods. You
may refer to the hints by touching the
• Casserole lid.
• Plastic wrap: Use plastic wrap recommended for microwave cooking. Cover dish loosely; allow
approximately 1/2 inch to remain uncovered to allow steam to escape. Plastic wrap should not
touch food.
• Wax paper: Cover dish completely; fold excess wrap under dish to secure. If dish is wider than
paper, overlap two pieces at least one inch to cover.
Be careful when removing any covering to allow steam to escape away from you.

SENSOR POPCORN / SENSOR REHEAT

SENSOR POPCORN / SENSOR REHEAT
You can pop popcorn and reheat many foods and don't need to calculate cooking time or power level.
Touch
SENSOR REHEAT
The Sensor Popcorn setting has 2 choices. Follow directions in the display to choose desired option.
When the sensor detects the vapor emitted from the food, the remainder of cooking/reheating time
will appear.
14
©2021 Hestan Commercial Corporation
STOP/CLEAR
pad and cook manually.
will be displayed, and the microwave will turn off.
or
SENSOR POPCORN
(CONT.)
during this part of the cycle. The measurement of
pad when the HELP indicator is lighted in
SETUP/HELP
pad. See page 21.
SETUP/HELP
and
add minute
START/
pad.