General International BG6001 Manuel D'installation Et D'utilisation page 10

5. Remove the bolt, washers and nut from the eyeshield.
6. Position the eye shield on the spark deflector / shield bracket as shown
in fig 5.
7. Place a long bolt through one side of the the spark deflector bracket and
thread into the eye shield, the other side of the bracket and finish with
the flat washer, lock washer, and nut to secure the eye shield onto the
spark deflector bracket.
8. Rotate the wheel by hand one full revolution to ensure the wheel can
rotate without contacting the spark deflector bracket.
9. Firmly tighten the bolts and nuts retaining the bracket and shield.
10. Repeat for the opposite side.
NOTE: Always check to ensure the eye shields are correctly fitted and
the eye shield spark deflectors are correctly adjusted each time the
grinder is used. Eye shields and spark deflectors must be fitted over
each grinding wheel.
ATTACHING TOOL RESTS
Tool rests are required for each high speed grinding wheel to assist in the
grinding operation.
WARNING! To reduce the risk of injury, never use a bench grinder on
which the tool rest has not been fitted or where the tool rest has not been
correctly adjusted.
NOTE: The tool rests are right and left handed. Follow the diagrams to
ensure the correct tool rest is fitted to the correct side.
WARNING! To reduce the risk of injury, never connect plug to power
source outlet until all assembly steps are complete and until you have
read and understood the entire owner's manual.
1. Hold the tool rest in the correct position against the tool rest bracket (N,
fig 6) on the wheel guard.
2. Insert a short carriage bolt (1, fig 7) through the tool rest bracket and
then the tool rest, followed by a lock washer (2, fig 7), flat washer (3, fig
7), and locking knob (J, fig 7).
3. Tighten the locking knob sufficiently to support the tool rest but still
allowing the tool rest to slide inwards and outwards.
4. Slide the tool rest to within a maximum of 1/16" (1.5 mm) from the
surface of the wheel.
5. Rotate the wheel one full revolution by hand to ensure the wheel does
not contact the tool rest.
6. Tighten the locking knob firmly to retain the tool rest position and angle.
7. Repeat the assembly operation for the second tool rest.
MOUNTING THE GRINDER
We recommend you mount the grinder on a stable bench.
WARNING! To reduce the risk of injury, never connect plug to power
source outlet until all assembly steps are complete and until you have
read and understood the entire owner's manual.
1. Before operating the bench grinder, it should be firmly mounted to a
workbench or another rigid framework.
2. Use the holes in the base of the bench grinder (L, fig 2) to mark and pre-
drill the mounting holes. If it is to be used in one location, permanently
secure it to the work surface. Use bolts, washers, lockwashers and
nuts, keeping in mind the inherent vibration a bench grinder in operation
produces.
3. Alternatively, the bench grinder could be mounted to a piece of 3/4" (19
mm) thick plywood at least 12" x 18" (30 x 46 cm) to prevent tipping.
This could then be attached to any convenient stable support with
C-clamps when and where needed.
10
!