MiFi 7000 Guide Utilisateur page 50

LAN
From LAN settings, you can manage your MiFi's network. These settings include:
IPv4
•
IP address — The IP address for the MiFi.
•
Subnet mask — The subnet mask network setting for the MiFi. The default value
•
255.255.255.0 is standard for small (class "C") networks. If you change the LAN IP Address,
make sure you use the correct Subnet Mask for the IP address range containing the LAN IP
address.
MAC address — The Media Access Controller (MAC) or physical address for the MiFi.
•
Turn On DHCP server — The Turn On DHCP Server checkbox turns the DHCP Server feature
•
on or off. Normally this should be left turned on.
Start DHCP address range at — The start range of IP addresses reserved for use by the
•
MiFi's DHCP server table.
DHCP address range — The current range of IP addresses reserved for use by MiFi's DHCP
•
server table. If a device with a static IP address wants to connect to MiFi 7000's network,
the static IP should be outside of the DHCP address range. Most devices do not have a
static IP.
DHCP lease time — Use to determine how often connected devices must renew the IP
•
address assigned to them by the DHCP server. Normally this is left at the default value, but
if you have special requirements you can change the value.
IPv6
•
Enable IPv6 — The Enable IPv6 checkbox turns ON/OFF the IPv6 feature.
•
Link-Local address — Displays the local address when IPv6 is turned on.
•
Remember to Save Changes if you change any settings.
MiFi Settings Advanced - LAN
46