Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fixing the Frame/Chimney
Should it be necessary to adjust the height of the frame, pro-
ceed as follows:
• Unfasten the metric screws joining the two opposite parts
that can be seen from the front;
• Adjust the height of the frame as required, then replace the
screws removed as above, making sure that you insert 2 of
them close to the panel lock;
• Lift the frame, insert the slots onto the screws and slide
them until they lock;
• Tighten the two screws and insert the other two screws
provided.
• Take the telescopic chimney locking bracket 7.2, remove
the film from the double sided adhesive and fix it inside the
frame so as to hold it more firmly.
Before final locking of the screws it is possible to make small
adjustments to the frame, making sure that the screws do not
come out of the adjustment slot.
• The Frame must be securely fastened both due to the
weight of the Hood and the stress caused by occasional
sideways pressure on the Appliance when in position.
When fastened, check that the base is stable even when the
Frame is subjected to bending.
• In all cases where the Ceiling is not sufficiently strong at
the point of suspension, the Installation technician must
strengthen it with suitable plates and counterplates, an-
chored to structurally sound elements.
Ducted version air exhaust system Connection
When installing the ducted version, connect the hood to the
chimney using either a flexible or rigid pipe ø 150 or 120
mm, the choice of which is left to the installer.
• To install a ø 120 mm air exhaust connection, insert the
reducer flange 9 on the hood body outlet.
• Fix the pipe using the pipe clamps 25 (not provided).
• Remove any activated charcoal filters.
EN
1
1
2
2
ø 120
ø 150
9
9
9
Publicité
Table des Matières
