Cleaning And Maintenance - Philips PT927 Mode D'emploi

2 Push the trimmer slide downwards to open the trimmer.
, You can now start trimming.
3 After trimming, close the trimmer and switch off the shaver.

Cleaning and maintenance

Never use compressed air, scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean the shaver, the
charging stand (PT927/PT925/PT923/PT920/PT876/PT875 only) and the
Jet Clean System (PT927CC/PT923CC only).
- The best and most hygienic way to clean the shaver is in the Jet Clean
System (PT927CC/PT923CC only). You can also rinse the shaver under
the tap or clean it with the cleaning brush supplied.
- Clean the shaver after every shave for optimal shaving performance.
- Regular cleaning guarantees better shaving performance.
For the best cleaning results, we advise you to use the Philips Cleaning
-
spray (HQ110) and (PT927CC/PT923CC only) the Jet Clean solution
(HQ200).
Be careful with hot water. Always check if the water is not too hot, to
-
prevent your hands from getting burnt.
Note: Water may leak from the socket at the bottom of the shaver when you
rinse it. This is normal and not dangerous because all electronics are enclosed
in a sealed power unit inside the shaver.
Cleaning the shaving unit under the tap
1 Switch off the shaver and disconnect it from the mains.
2 Press the release button to open the shaving unit.
3 Rinse the shaving unit and hair chamber under a hot tap for
30 seconds.
Be careful with hot water. Always check if the water is not too hot, to
prevent your hands from getting burnt.
English
11