Philips PT927 Mode D'emploi page 15

2 Press the on/off button on the Jet Clean System to start the cleaning
program.
, The battery symbol on the Jet Clean System goes out.
During the cleaning program, the cleaning symbol starts to lash and
,
the shaver is automatically lowered into the cleaning luid.
The shaver automatically switches on and off several times
,
and moves up and down.
The cleaning symbol lashes throughout the cleaning program, which
,
takes approx. 8 minutes.
, After the cleaning program, the battery symbol on the Jet Clean
System goes on to indicate that the shaver is being charged.
Note: If you press the on/off button of the Jet Clean System during the cleaning
program, the program aborts and resets. In this case, the cleaning stops
lashing and the shaver holder returns to its starting position. The shaver may
still be wet and dirty, because the cleaning program has not been inished.
Note: If you remove the adapter from the wall socket during the cleaning
program, the program aborts. The shaver holder remains in its current position.
When you put the adapter back into the wall socket, the shaver holder moves
to its highest position.
Note: When the luid level drops below the minimum level, the cleaning symbol
and the 'luid low' symbol start to lash with intervals and the shaver holder
returns to its starting position
Cleaning the Jet Clean system
Empty the cleaning chamber and clean it thoroughly by rinsing it with hot
tap water every 15 days if you use the Jet Clean System daily. Otherwise
empty and clean the cleaning chamber at least once a month.
1 Clean the outside of the Jet Clean System with a moist cloth.
Never immerse the Jet Clean System in water, nor rinse it under the tap.
2 Simultaneously press the release buttons on both sides of the Jet
Clean System (A). Then lift the Jet Clean System off the cleaning
chamber (B).
The cleaning chamber remains behind.
,
Pour any remaining cleaning luid out of the cleaning chamber.
3
You can simply pour the cleaning luid down the sink, this is not harmful to
the environment.
4 Rinse the cleaning chamber under a hot tap.
Be careful with hot water. Always check if the water is not too hot, to
prevent your hands from getting burnt.
The cleaning chamber is not dishwasher-proof.
English
15