Table des Matières
Publicité
Safety Instructions
1.
Do not attempt to assemble the screenhouse
under windy conditions.
2.
In the event strong winds or storms are
forecasted, disassemble and store in a safe place.
Minimum precaution requires removal of the roof.
3.
While this screenhouse meets CPAI Code 84
requirements for flame retardancy, it is NOT fire proof.
Keep open flames and flammable materials outside and
at a safe distance from your screenhouse.
1. Prior to assembly
A.
To safely and easily assemble the screenhouse
a minimum of two people are needed. You will need
screwdrivers, a nut driver, an adjustable wrench, and a
power drill.
B.
You should erect your screen room on as level
and solid a base as possible.
C.
Remove the vinyl roof, roof tubes, vinyl hinges
and the door hardware and inventory parts as listed on
page 9 for your model.
2. To assemble the wall
A.
The panels come pre-attached with vinyl hinges
in the box. Form a rough square with screening on the
outside like a diagram, making certain center bars are
inside the room.
B.
Position the empty door frame where you desire
the door.
C.
Line up the edge of the two end frames.
holding one end of the vinyl hinge vertically above the
two frames, slowly insert it simultaneously into both
frames until completely inserted.
3. Door installation
To install as pre-assembled in factory, take the (14-
030) plastic tracks from the box and slide them onto the
extrusion at the top and bottom of the door opening.
L:\WP51\INSTRUCTIONS\WEB VERSIONS\41124 Children's Gazebo 20190614.docx
The open side should face down for the top track (2
holes) and up for the bottom track (no holes).
A.
are at the bottom and the screen towards the outside of
the room, then drill two holes for the handles (85-050)
at the height you desire.
B.
vertical sides of the door frame, facing inwards.
4. Frame fixture
Take brackets (94-233 or 94-219) and screw onto top
corners between each pair of frames. The screws that
fall within the closed position and travel of the door
must be screwed on from the inside out, so as not to
impede its movement (3 screws total).
5. To assemble roof
A.
in the center of the screen room holding the 6-finger
hubs (88-105) that will join the tubing.
B.
as per the diagram below. Place one end of a tube on
the hub, insert a tube tip into the other end of the tube,
and place the tube tip through the corresponding
bracket, as shown in the picture.
4
3
D.
While
3
4
Slide door into position. Make sure the wheels
Install weather strip (85-058) on both 60''
One person should be on a stool or stepladder
A second person should take the tubes in order
41124
4
2
2
3
1
3
2
2
4
1
26 ½"
2
42"
3
32 ¼"
4
49 ¾"
2
Publicité
Table des Matières
