Poollux Inverter Style 7029600 Notice D'installation Et D'utilisation page 19

6.1. The Icon definition and operation
6.1.1
Click the
6.1.2
Click to switch the working mode:
mode(setting range from 6
The heating icon
6.1.3
Click to switch the running mode.
In heating or cooling mode, there are three running modes (Silent, Smart, Powerful) for options.
While in Auto mode, its default running mode is Smart.
6.1.4
Click the water temp. zone, IN, OUT and SET will display in order by each click.
You can set the desired water temperature by sliding up and down the digits (6-41) when SET temp. shows.
6.1.5
Click
connection.
6.1.6
. If error code occurs, it will display at the upper left.
6.1.7
If it is connected to WIFI module, upper right
6.2
Click to enter the Parameter query or setting, Temp & COP curve, Timer ON/OFF and Error code.
6.2.1 Parameter query
There are four interfaces (Parameter A-D) including d0 to d11, which is listed as below. Click
top & right side to switch to next parameter interface.
to turn on or off the heat pump
-35 ), Auto mode(setting range from 6
℃ ℃
flashes under defrosting mode.
to set the time, it could be automatically synchronized with the network time if network
Heating mode(setting range from 6
-41
℃
icon will be long bright.
16
-41 ),
℃ ℃
) .
℃
from the screen's
Cooling