Cleaning In The Dishwasher; Cleaning By Hand - Krups EPC09 Série Manuel D'utilisation

CLEANING IN THE DISHWASHER:

you can place the metal lid in the
dishwasher, without removing the valves.
After placing in the dishwasher, remove the
ball and blow in the pipe to check that it is
not blocked. Dry the ball and its support
carefully using a soft cloth.
Before reinstalling the ball, check that the
pipe is not blocked by blowing into it.
Before removing the internal lid, clean the upper part of the cooking pot. Clean the inside
of the appliance's metal lid using a damp sponge and check that the manometric rod is
properly positioned to ensure that it is not blocked.
Rinse under water and check the mobility of the safety pin.
Replace the watertight seal at least
every three years. This operation will be
performed in an Approved Service Centre.

CLEANING BY HAND:

you can clean the metal lid using soapy hot
water. Firstly, remove the ball then clean
completely. Dry the ball and its support
using a soft cloth.
Press on the internal part of the safety
valve spring to check that it is not clogged.
Do not store the appliance with the lid
closed. Leave open or half open; this will
prevent unpleasant odours.
127 127