Operating - GreenWorks Commercial GH 260 Guide D'utilisation

OPERATING

To install the battery (See Figure 2.)
IMPORTANT! The battery pack (GL 200, GL 250, GL 300, GL 400, GL 500, GL 900) is not charged
when it is purchased. Before using the hedger for the first time, place the battery pack on the
battery charger and charge. Make sure to read all safety precautions, and follow the instructions
in the Battery Charger section.
1. Align the grooves (3) of the battery pack with the cavity in the handle housing.
2. Grasp the rear handle (2)
3. Push the battery pack into the handle until the latch locks into place.
NOTE: The battery pack fits snugly into the handle to prevent accidental dislodging. It may require a strong pull
to remove.
To remove the battery (See Figure 2.)
1. Press the latch button (1) on hedge trimmer down and hold.
2. Grasp the rear handle (2)
IMPORTANT! DO NOT remove the blade assembly unless it needs sharpening, straightening, or
replacing. Take it to a
W A R N I N G
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or
• Replace the battery pack or the charger immediately if the battery case or charger cord is
damaged.
• Verify that the switch is in the OFF position before inserting or removing the battery pack.
• Verify that the battery pack is removed and the switch is in the OFF position before
inspecting, adjusting, or performing maintenance on any part of the hedge trimmer.
• Read, understand, and follow the instructions contained in the section entitled Charging
Procedure.
firmly. Pull the battery pack out of the handle.
person for repair.
10
1
2
3
Fig. 2