General; Information On Environmental Protection - Titan PLC 456 000100 Notice D'installation

2.

General

This operating manual is intended to acquaint the operator with the devices and facilitate the
use of the devices as intended. The operating manual contains important information on how
to use the devices safely, correctly and economically. Following the instructions helps avoid
risks, reduces repairs and downtimes and increases reliability and life of the unit.
The operating manual must always be available at the location where the devices are in use.
It must be read and understood by all persons who work with the devices. Such work
includes in particular operation, troubleshooting and maintenance.
In addition to the safety information in the operation manual and the applicable local accident
prevention regulations, all persons must also comply with recognized safe and correct
working procedures.
Explanatory notes on the warning and instruction symbols:

2.1. Information on environmental Protection

This tool is manufactured without any physical or chemical substances which could be
dangerous to health. For disposal of all the parts, the governmental instructions must
be observed.
Copyright © TITAN Umreifungstechnik GmbH & Co.KG 2011 All rights reserved.
The contents of this document must not be duplicated, handed to third parties, published or saved in any form,
neither fully nor partly, without prior written permission by TITAN Umreifungstechnik GmbH & Co.KG.
PLC / DCR / SCR
Caution!
Used to indicate danger to life and limb.
Attention!
Used to indicate danger that can result in material damage.
Notice!
Used to indicate general information and information which if
ignored can cause disruptions in operation.
is a registered trademark of TITAN Umreifungstechnik GmbH & Co.KG.
H456 EU 07/10
23 / 71