Operation - Omcan CE-CN-G15M Manuel D'instructions

Installation
• If the U burner does not ignite, open the pilot valve more.
• If the pilot flame appears larger than necessary, turn it down and reset burner ignition.
• The pilot flame should be as small as possible but large enough to guarantee reliable ignition of the burners
when the knobs are turned to "I"
Note: Please check leakage before re-installing the control-panel.

Operation

LIGHTING INSTRUCTIONS
FOR THERMOSTAT MODELS
Lighting the Main Burners
These Griddles are fitted with individual standing pilots for each burner. Flame Failure Protection is
incorporated for each burner by way of a thermo-electric system which will shut off the gas supply to that
burner in the event that the burner goes out, so that un-burnt gas is not expelled.
• Select the burner required, depress and turn the corresponding gas control knob anti-clockwise to the
'PILOT' position.
• With the gas control knob depressed, manually light the pilot burner.
• Release the gas control knob after approximately 10-20 seconds after lighting the pilot burner.
• The pilot burner should stay alight - if not, repeat the above steps.
• Rotate the gas control knob anti-clockwise to the desired temperature mark.
• The main burner will be now ignited automatically.
Turning 'OFF' the Main Burners / Pilots
• To turn 'OFF' the main burner, but keep the pilot burner lit, rotate the gas control knob to the 'PILOT'
position. The main burner will extinguish and the pilot will remain lit.
• To turn 'OFF' the 'PILOT', depress and turn the gas control knob clockwise back to the 'OFF' position. The
'PILOT' burner will extinguish.
Note: Please wait at least 15 seconds to restart the main burners to maintain the best function of the
thermostat valve after turning off the main burners.
FOR MANUAL MODELS
The pilot light on the appliance has been set at the factory. A screwdriver maybe required for the first lighting to
adjust the flame for your elevation.
1. Turn off the manual valve and wait 5 minutes to clear the gas.
2. Turn all knobs to the "OFF" position.
3. Hold an ignition source (match) at the pilot. When the flame is established, remove the ignition source.
4. Turn the burner knobs to "ON". If the burner does not ignite, promptly open the pilot valve more. If the pilot
12