ShelterLogic MaxAP 23521 Mode D'emploi page 5

5. plAce cover AnD secUre to cAnopY FrAMe
A. Place cover over assembled roof frame with grommet panels facing down, aligned with cross rails.
B. Make sure the cover is properly aligned on the frame, secure the four corners of the cover with bungees
to the frame first
(10066)
Re-adjust bungees position along cross pole as needed to ensure a tight and even fit of the cover to the frame.
Grommet Panels for Bungees
10066
Grommet
Panel
13103
13105
6. tiGHten tHe cover WitH tWist tite
A. Wrap the cord with plastic ball and "S" hook at the corners of the cover
around the corner leg poles. Insert "S" hook into the hole of the corner leg
poles.
B. Twist each leg pole toward the inside of the shelter until the cover
becomes tight. Twist the leg poles equally to ensure the cover stays
aligned during tightening.
Attach remaining bungees.
.
Insert Bungee Cord Through Grommet
13104
10372
13101
™
Page 5
Grommet Panels for Bungees
Grommet Panel
13106
13103
10372
Secure Bungee Around Plastic Ball
Twist-Tite ™ Tighten Cover
10372
13101
13105
05_23521_0E