Tiiwee A2 Mode D'emploi page 3

Pairing with remote control and sensors
Pairing with remote control
Your PIR motion sensor alarm is already paired with the supplied remote control. Pairing additional remotes is
easy. In general, the pairing mode is activated on the PIR motion sensor. Then, activate (trigger) the detector to
allow the PIR motion sensor alarm to recognize the signal. At this stage, multiple remotes can be added by
activating them one by one. They will be paired with the PIR motion sensor alarm immediately and
automatically. Each PIR motion sensor alarm can be paired with 5 or more remote controls and each remote
control can control multiple PIR motion sensors simultaneously. This means that each member of your family
or team can switch the system on or off when they require it. Your home will never be unprotected. Follow the
steps below to add a remote control:
•
Make sure the PIR motion sensor alarm is ON
•
On the PIR motion sensor alarm, long press the Pairing button
detector light will light up continuously.
•
Press any button on your remote control. You will hear two beeps to indicate correct pairing
•
Short press the Pairing button
Multiple remotes can be connected to any PIR motion sensor. Also, the remote control can be linked to
multiple PIR motion sensor alarm using the method described.
Pairing with Tiiwee Alarm System sensors
Extend your PIR motion sensor alarm with additional sensors. Your PIR motion sensor alarm can wirelessly be
connected with additional sensors from the Tiiwee Home Alarm System. The system features window & door
sensors and additional PIR Motion Sensors. Triggering any sensor will cause your PIR motion sensor alarm to
sound either a Siren or a Chime.
Sensors can be setup as an emergency sensor or as a normal sensor. An emergency sensor is a sensor that is
supposed to be always on (meaning: never disarmed). This sensor will always trigger an alarm even if the A2
PIR motion sensor alarm is disarmed. When the sensor is triggered, you can stop the alarm by pressing any of
the three buttons on the PIR motion sensor alarm.
To add sensors please follow this simple procedure:
- Enter pairing mode by long pressing the Pairing button
of setting up an emergency sensor). The detector light will light up continuously.
- Activate your sensor. With a door & window sensor, just remove the magnet away from the sensor to
activate it. A PIR sensor can be activated by waving your hand in front of it.
- You will hear two beeps indicating a correct pairing occurred.
- Short press the Pairing button
sensor).
Multiple sensors can be paired with a PIR motion sensor alarm.
【 】
to exit the pairing mode. Your remote has now been paired.
【 】
(or the Mode button
【 】
to enter pairing mode. The
【 】
(or the Mode button
【 】
in case of an emergency
【 】
in case