Luisi Air UDINE SLT958 Instructions D'installation Et D'utilisation page 9

for 2 seconds. When Leds light on, press buttons:
(within 5 seconds). Leds flashing 6 times indicate
the procedure is completed.
WARNING! This operation deletes permanen-
tly the preset codes.
Emergency button:
In the event that the radio control does not work,
use the emergency button to switch the appliance
off. After any necessary repairs have been perfor-
med, reset the emergency button.
WARNING
The battery should be replaced every year to
guarantee the optimal range of the transmitter.
To replace the exhausted battery, take the pla-
stic lid off, remove the battery and replace it
with a new one, observing the correct battery
polarities.
Used batteries should be discarded in special
collection bins.
The below product:
RC001 Radiio Controll
complies with the specifications set out in the
R&TTE Directive 99/5/EC.
WARNING
Any adjustments or modifications which have
not been expressly approved by the holder of
the legal conformity certificate may invalidate
the user's rights relating to the operation of
the device.
The products are endowed with an electronic de-
vice which allows the automatic switching off after
4 hours working from the last operation.
Rev. 0 26/08/14
As a result of the new EU65 "Energy Label" and
EU66 "Ecodesign" regulations issued by the Eu-
ropean Commission, which came into force as
from January 1st 2015, our products have been
adapted to comply with these new requirements.
All of the models complying with the energy label
requirements, are equipped with new electronics
including a timer device for suction speeds con-
trol, when the air capacity exceeds 650 m3/h. In-
ternal motor models, with maximum air capacity
higher than 650m3/h, are equipped with a timer
device that automatically switches the suction
speed from 4th to 3rd speed, after 5 minutes of
operation.
The energy consumption of the appliance in
stand-by mode is lower than 0.5 W.
MAINTENANCE
An accurate maintenance guarantees good fun-
ctioning and long-lasting performance. Special
care needs to be taken with the grease filter:
to access the filter, proceed as described in the
PANEL OPENING chapter.
Remove the grease filter, using the specific han-
dle.
To refit the grease filter after cleaning, carry out
the same operation in reverse order.
To remove the carbon filter, if fitted, follow the
same steps as for the grease filter.
The carbon filter is located immediately above
the grease filter.
Tepid water and neutral detergents are recom-
mended to clean the appliance, while abrasive
products should be avoided.
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a simi-
larly qualified person in order to avoid a hazard.
9
TIMING