Filtering Version - Luisi Air UDINE SLT958 Instructions D'installation Et D'utilisation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

H95170006 - H95170015

INSTALLATION

Take the product out of the packaging and place

it on a suitable surface: we suggest to use a soft

material like a sponge or a cloth.

This information is very important for the creation

of the plasterboard structure.

Installation entails the lowering of the plasterbo-

ard ceiling, as the appliance shall be installed at

a maximum distance of 2100mm from the floor in

order to ensure good operation and performan-

ces The hood can be installed at a minimum di-

stance of 300mm and at a maximum distance of

480mm from the solid ceiling.

In case ceiling lowering results greater than the

aforementioned maximum distance required, you

will need to use longer threaded bars.

In order to make installation operations easier,

we suggest to create only the metal structure clo-

se to the hood, without using the plasterboard.

Please remember that the recess which will hou-

se the hood should be 1065x665mm and that the

weight of the plasterboard shall not rest on the

hood.

Provide the area where the hood is being in-

stalled with power supply and with the 150mm

diameter or similar section duct necessary to di-

scharge the air.

Draw the holes for installing the appliance on the

solid ceiling (Fig. 3). Drill the holes previously

outlined using an 8mm diameter twist drill and

secure the metric dowels and the threaded bars

supplied into the holes (fig. 4).

The appliance has the motor air outlet positioned

on its short side; nevertheless you can choose

the side of the hood from which collected air is

to be discharged as follows: open the panel, fol-

lowing the instructions given in the 'USAGE' sec-

tion and remove the grease filters.

Remove the 4 screws, as shown in figure 5.

Remove the lower plate , as shown in figure 6.

Remove the motor fixing screws, as shown in fi-

gure 7.

Make a hole either in the center of the hood top

side (fig. 8) or long side (fig. 9).

Fix the metal cover where the motor was previou-

sly placed using the four screws supplied. (fig. 10).

If you choose to install the motor with the air out-

let directed upwards, installation will not entail the

use of the motor supporting metal plate , as the

motor will be fixed directly on the hood body, as

shown in figure 11.

Bring the hood close to the ceiling and carry out

the electrical and the air outlet duct connection

as well.

Install the hood on the ceiling and secure it by

screwing the nuts supplied to the threaded bars.

(fig. 12).

If you choose to have the air outlet on the hood

short side, the exhaust duct fixing operations can

be made easier by removing the cover shown in

fig. 13.

The plasterboard structure shall not rest on the

hood.