BH LK700E CORE Guide D'utilisation page 15

STEP 2: ATTACHING THE CONTROL TUBES TO THE FRAME
Place the Bushing (G) into the Controle Tube Set (A) ( on each side ), then slide the arm
of the Control Tube Set (A) into the arm coming from the Frame (B). Secure the arm of
the Control Tube Set (A) into the arm coming from the Frame (B). Secure the arm of
the Control Tube Set (A) to the arm of the Frame (B) with 1 Hex Screw (K03), 1 Spring
Washer (K07), 1 Washer (K04) And 1 Nut (K05). Fit the Joint Cover (C) and Joint Cover
(D) so they come together on either side of the joint and secure with 1 Phillips Screw
(K01) and 2 Phillips Screw (K02).
*Use this procedure for both left and right connections.
15