Installation And Start-Up - Promax GV-698+ Manuel D'utilisation

CAUTION THE EQUIPMENT IS FACTORY SET FOR 220 V OPERATING
VOLTAGE.
BEFORE SWITCHING ON THIS INSTRUMENT, SET THE VOLTAGE
SELECTOR TO THE PROPER POSITION AND BE SURE THAT THE
FUSE VALUE IS ACCORDING TO THE MAINS VOLTAGE.
AVOIDING THIS DIRECTIONS COULD DAMAGE THE EQUIPMENT.

3.2 Installation and start-up

The equipment is prepared for use as desk top equipment.
After having selected the power supply voltage, the equipment may be
connected to the mains and switched on by activating the mains switch LINE [1]; after a
few seconds the LCD display will show present configuration parameters
corresponding to the video and audio section, stored in memory location 00. All the
outputs and inputs of the generator will remain at the state indicated on the
configuration of this memory position.
The equipment's highest level of performance is obtained at about 15 minutes
after switching on.
Page 16
Colour pattern generator GV-698+
07/2018