Danger Of Fire; Hanging Installation; Danger To Life - EuroLite FLASHLIGHT TUBE Mode D'emploi

If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, lamp explosion, crash etc.
INSTALLATION
Rigging
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
The device can be installed on the ground or on the wall or ceiling.

Hanging installation

Please consider the EN 60598-2-17 and the respective national norms during the
installation! The installation must only be carried out by an authorized dealer!
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The device should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the device. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The device has to be installed out of the reach of people and must never be fixed swinging freely in the
room.
The device must be installed in an absolutely horizontal position.
Always install the device via all fixation holes. Do only use appropriate screws and make sure that the
screws are properly connected with the ground.
Procedure:
Step 1: Remove the clamp rings and fixation screws from the packaging (1 pair of each accessory per
tube) and clamp the rings onto the tube.
Step 2: On the clamp rings, there are 2 holes for the installation.
Step 3: Hold the device with attached clamp rings onto the location where the device is to be installed.

DANGER OF FIRE!

DANGER TO LIFE!

9