Using The Appliance - Philips AVENT SCD600 Mode D'emploi

Masquer les pouces Voir aussi pour AVENT SCD600:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3
Insert four non-rechargeable batteries (Fig. 7).
Note: Make sure the + and - poles of the batteries point in the right direction.
4
Reattach the lid.
5
Fasten the screw with a flathead screwdriver.
parent unit
Battery operation (rechargeable battery)
Unplug the parent unit and make sure your hands and the unit are dry when you insert the
rechargeable battery.
The parent unit comes with a rechargeable Li-ion 1050mAh battery.
Charge the parent unit before you use it for the first time or when the parent unit indicates that the
battery is low (when the empty battery symbol flashes on the video display and the battery light on
the parent unit flashes green).
Note: If the battery is completely empty, the parent unit automatically switches off and loses contact with
the baby unit.
1
Slide down the battery compartment lid to remove it (Fig. 8).
2
Insert the rechargeable battery (Fig. 9).
Note: Make sure the + and - poles of the battery point in the right direction.
3
Reattach the lid (Fig. 10).
4
Insert the appliance plug into parent unit and put the adapter in a wall outlet (Fig. 11).
The battery light on the parent unit lights up blue and the video display shows a battery
,
symbol (Fig. 12).
When the battery is fully charged, the battery light turns green.
,
-
When you charge the parent unit for the first time or after a long period of non-use, switch it
off and let it charge continuously for at least 4 hours.
-
Charging normally takes 3.5 hours, but it takes longer when the parent unit is switched on
during charging. To keep the charging time as short as possible, switch off the parent unit during
charging.
-
When the batteries are fully charged, the parent unit can be used cordlessly for at least 8 hours
if it is in automatic screen activation mode. If the video is on continuously, the parent unit can be
used cordlessly for approx. 6 hours.
Note: When the parent unit has been charged for the first time, the operating time is less than 6 hours.
The rechargeable battery only reaches its full capacity after you have charged and discharged it four
times.
Note: The battery gradually discharges, even when the parent unit is switched off.

Using the appliance

Use the video monitor for its intended household use as described in this manual.
1
Place the parent unit and the baby unit in the same room to test the connection (Fig. 13).
Make sure the baby unit is at least 1 metre/3 feet away from the parent unit.
2
Set the ON/OFF switch on the baby unit to the ON position. (Fig. 14)
The green power-on light goes on. (Fig. 15)
,
Note: The power-on light always lights up green, even when there is no connection with the parent unit.
EngliSh
11

Publicité

Table des Matières
loading

Table des Matières