FLAEM Hospi Neb Mode D'emploi page 9

Appareil aérosol pour utilisation fréquente
Masquer les pouces Voir aussi pour Hospi Neb:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
• The Manufacturer, the Retailer and the Importer are responsible for the safety, reliability and
performance of the device only if: a) the device is used in accordance with the operating instructions
b) the electrical system of the premises where the device is used is in compliance with current laws.
• Interactions: The materials used that come into contact with medications have been tested with a
wide range of medications. However, due to the variety and continuous evolution of medication,
the possibility of a chemical interaction cannot be excluded. We recommend that once the
medication has been opened you should use it as soon as possible and avoid prolonged contact of
the medication with the nebulizer.
INSTRUCTIONS FOR USE
Before each use, the nebuliser and accessories should be cleaned according to the instructions in the
section "CLEANING, SANITIZATION, DISINFECTION AND STERILIZATION" A personal use of the nebuliser
and its accessories is recommended in order to avoid any risks of infection.
1. Insert the power cord (A7) into a power socket corresponding to the voltage of the device. This must
be positioned so that it is not difficult to make the disconnection from the mains.
2. open the nebuliser by turning the upper part (C5.1) anticlockwise.
3. Pour the drug prescribed by the physician into the lower part (C5.3). Close the nebuliser by turning
the upper part (C5.1) clockwise.
4. Connect the accessories as shown in the "Assembly diagram". Sit comfortably, holding the nebuliser
in your hands, place the mouthpiece over your mouth or use the nasal prong or mask.
5. Start the unit by means of switch (A1) and breathe in and out deeply.
6. When the treatment is finished, turn off and unplug the unit.
7. It may happen that after a treatment session visible humidity deposits form in the tube (B): disconnect
the tube from the nebuliser and let it dry using the compressor air flow, as this prevents mould from
growing in the tube.
HOW TO USE RF6 PLUS NEBULISER WITH DOUBLE ACTION VALVE
It is professional, quick and suitable for administering all types of drugs, including more costly ones,
also in patients with chronic diseases. The configuration of the internal lines of the RF6 PLUS nebuliser
ensures the ideal granulometry providing effective treatment right down to the lower airways.
USE WITH MOUTHPIECE
Use the double action valve (C5.4) in position 1. In this case the
inhalation therapy allows the maximum drug intake and therefore
the maximum therapeutic effect, minimising the loss of medication.
USE WITH MASK AND NASAL PRONG
To make inhalation therapy faster we recommend using the
double action valve (C5.4) in position 2.
To administer the medication only through the nose, use the
non-invasive nasal prong (C4).
NON-SPILL SYSTEM
The RF6 PLUS nebuliser is also especially suitable for pediatric
use, since the non-spill system prevents medication from
spilling out even if the nebuliser is accidentally tipped over.
USE WITH MASK AND NASAL PRONG
Efficacy tested up to 5 ml, the average dose
7
USE WITH MOUTHPIECE
VALVE IN
PoSITIoN 1
VALVE IN
PoSITIoN 2
recommended for normal use

Publicité

Table des Matières
loading

Table des Matières