Publicité
Les langues disponibles
Les langues disponibles
Installation guide for the 4 holes bath faucet Eiffel series
Important: For the handles' adjustment, rotate the cartridge in the closed position
(cold side turned counter-clockwise, hot side turned clockwise).
A. On each spindle (10), from underneath the worktop, put a set including: a nut (7), a
washer (8), and a gasket (9). Insert each spindle from underneath the worktop, then
do the same on top. Adjust the spindles' height according to the handles' flange (6),
using the provided template (30).
B. Screw the flange (6) onto the spindle (10). Slide the rod (5) through the flange (6).
Install onto the spindle (10), then insert the plastic ring (4).
C. Insert the screw (3) through the rod (5), then screw to the spindle (10).
D. From underneath the worktop, insert the diverter (13) into the central hole in between
the handles with a nut (15), a washer (16), and a gasket (17). As for the top, put a
gasket (17), a washer (16), and the diverter's top nut (19).
E. Screw the diverter's top nut (19) all the way and finalize the assembling underneath
the worktop by tightening the nut (15).
F. Insert the spout (20) onto the diverter's top nut (19), making sure the diverter's rod
(18) is well slid into the spout's hole. Screw the set screw (29).
G. Insert the lever (12) onto the diverter's rod (18) and straighten with the set screw (11).
H. Connect the flexible hoses (14) from the diverter (13) to the spindles (10).
I. Into the remaining hole, insert the deck flange's (24) threaded shaft and the o-ring
(25). From underneath the worktop, assemble the gasket (23) and screw the nut (22)
all the way.
J. Screw the hand shower hose's (27) male connection to the hand shower (28), making
sure the gasket is being used. Slide the decorative flange (26) on the hand shower
hose (27) in order to be able to screw it to the hand shower (28), then pass the other
end through the deck flange (24).
K. Connect the flexible hoses (14) from the spindles (10) to the diverter (13).
L. Assemble the handles (1) onto the rod (5) with the set screw (2).
M. Finalize the assembling underneath the worktop, by tightening the nut (7). DO NOT
OVER TIGHTEN.
N. Fix together the hand shower hose (27) and the flexible hose (21). Connect the flexi-
ble hose (21) to the diverter (13).
O. Connect water supplies to the spindles: Hot on the left side and cold on the right side.
P. Check all joints for leaks.
*The positioning of the gasket (9) is important. The ridge on it is there to help center the
spindle (10) in the opening. The spindle with the mark is for the cold water side.
Gui-12 rev 11 09/2012
15
Eiffel series 4 holes bath faucet
Gui-12 rev 11 09/2012
16
30
Publicité
