Genie LT-400 Guide D'utilisation page 11

serviettes for example, with thicker films (125 microns). We recommend refraining
from any attempt to do so!
f) Do not insert any laminating film without the contents.
g) Never utilize laminating pockets on one side or when they are rolled up.
h) Only utilize laminating foils that are also described as such. Other kinds of film,
like transparent wallets for example, are unsuitable for laminating!
4. Insert the material within the laminating film straight and with the closed
side first into the feed opening on the machine's front side. The material
will feed it in automatically now.
5. The laminated material that emerges from the delivery opening on the
machine's back side is not allowed to be pulled out by force. Wait until it
has run out of the machine completely. Let the laminated material to cool
down briefly!
6. Switch off the machine after the laminating has ended, by setting the
switch to 'OFF'. Let the machine to cool down and always pull the plug out
of the mains socket outlet after using the machine.
Cold laminating ('Cold')
1. Push the plug into the mains socket outlet and set the switch to 'Cold'.
You can begin laminating whenever the LED lamp ('Ready') lights up
green.
2. Pull the protective sheet – if there is one – off the laminating foil.
Caution
a) Only utilize films for cold laminating that are expressly suitable for cold laminating.
b) It is recommended not to process several materials in one film.
c) Do not cut up the films before the laminating is done.
3. Proceed as described by points 3 to 6 in the section on hot laminating.
You do not have to bother about letting either the laminated material or
the machine cool down for cold laminating.
Change from hot to cold laminating
1. You can easily change to hot laminating by setting the switch to 'Hot'
whenever you have been using the machine in the cold laminating mode.
Wait until the green LED (operational indicator lamp) has been lit up for
approximately 3 minutes. The machine is ready for hot laminating now.
2. Now proceed as described by point hot laminating.
3. Set the switch to 'Cold' whenever you have been using the hot laminating
mode and you would like to change to the cold laminating mode. Please
note that the cooling down time amounts to approximately 2 hours for
switching over from hot to cold laminating. You can only begin the cold
laminating – as described by point cold laminating – whenever the LED
lights up green.
Attention: When the laminated pouch is ejected from the laminating film output it is
still hot und its shape may change slightly. For this reason, allow the laminated pouch
to cool down for at least 1 minute before touching it.
11