Genie LT-400 Guide D'utilisation page 10

Overview
(1) Laminating pouch entrance
(2) Laminating pouch output
(3) OFF (Trimmer)/ COLD/ ON\ HOT
(4) Power LED (red)
(5) Standby indicator (green)
(6) ABS (Anti-Blockage-System)
(7) Blade storage
(8) Cutting head
How to use the laminator
Hot laminating ('Hot')
1. Push the plug into the mains socket outlet and set the switch to 'ON'. The
red LED (operational indicator lamp) lights up and the heating process will
begin.
2. The green LED lights up after approximately 3 minutes (operational
indicator lamp for the hot laminating). Now you can begin the laminating
process.
3. Open the laminating film and lay the material that is to be laminated
directly onto the closed side. Leave a margin of between 3 mm and 5 mm
approximately beyond the edges while doing so.
Caution
a) Choose a film of correspondingly suitable size in relation to the material that is
to be laminated respectively.
b) It is not recommended to process several smaller materials in one film.
c) Do not cut up the film before the laminating is done.
d) The material that is to be laminated is not allowed to be thicker than 0.5 mm
including the film.
e) It is imperative to only laminate very thin or soft materials, like newspaper or
10