Assembling B310 Lever-Mechanism; Adjusting Lever Friction - Ultraflex B 310 Manuel D'installation Et D'entretien

ULTRAFLEX

3.7 Assembling B310 lever-mechanism

1 Insert bezel (A1) on
flange (3) by pressing it.
Insert the electric cable of
lever (A2) through the hole
of the cover.
2 Attach the lever unit using screw (M) and press
on cap (N).

3.8 Adjusting lever friction

1 Gain access to adjusting screw (21) by
drilling a hole in the circular impression of
bezel (A1) near the mechanism friction. Use a
6 (0.23") to 6,5mm (0.25") diameter punch or a
screwdriver.
A 1
21
A 1
Installation and maintenance manual
3
A2
M
N
2 Adjust throttle lever friction turning on screw
(21) with a Phillips head screwdriver (clockwise
to increase and counterclockwise to decrease
the friction). When adjustment is ended, close
the drilled hole by inserting the provided screw
cover (P).
21
NOTICE
This adjustment can be carried only after
disassembling the flange if the mechanism is
assembled in vertical position.
SINGLE LEVER CONTROL B310
P
page 15
- of 63