C14 And Mach14 Cable Installation; Shift Cable Connection; Throttle Cable Connection With Push Mechanism - Ultraflex B 310 Manuel D'installation Et D'entretien

ULTRAFLEX

3.4 C14 and MACH14 cable installation

3.4.1 Shift cable connection

1 Connect the terminal of the cable (H) to pivot pin (11)
located on the inner hole of the rocker arm (67 mm (2.64")
travel), then attach with snap ring (E).
2 Insert the cross cylinder of cable sheath end
into seat (e) if the terminal of the cable is
fastened in (e1) or into seat (f) if it is fastened
on the other side of the rocker arm (f1).
NOTICE
(Black) connector (G) and split pin (I) are not
used.

3.4.2 Throttle cable connection with push mechanism

1 Connect the
terminal of the cable
to the throttle lever
(16), then attach with
spring ring (E). Insert
the cross cylinder of
cable sheath end into
seat (h).
NOTICE
(Red) connector (F) and split pin (I) are not used.
page 12
of 63 -
SINGLE LEVER CONTROL B310
16
E
h
Installation and maintenance manual
E
e1
25
e
2 Attach casing fastener (O) with screws (L) to
prevent cable disengagement from control box.
L
O
11
H
f 1
f
L