Throttle Cable Connection With Pull Mechanism - Ultraflex B 310 Manuel D'installation Et D'entretien

ULTRAFLEX
3 Insert nut (10) on
the cable end and
screw the terminal
(H). Tighten nut (10).
Connect the terminal
to the throttle lever
(16) using snap ring
(E). The (red)
connector (F),
preassembled on the
cable, must be
installed in seat (g).

3.3.3 Throttle cable connection with pull mechanism

1 Remove rubber seals (13), (14) and nut (15)
(on the box side).
2 Insert the cable into the (red) connector (F)
and attach with the split pin (I), using seat (a).
a
WARNING
Insert and fold the long side of the split pin on the
connector to lock it.
3 Insert nut (10) on
the cable end and
screw the terminal
(H). Tighten nut (10).
Connect the terminal
to the throttle lever
(16) using snap ring
(E). The (red)
connector (F),
preassembled on
the cable, must be
installed in seat (g).
16
E
E
H
10
F
F
I
16
E
H
E
10
F
Installation and maintenance manual
4 Attach casing
fastener (O) with
screws (L) to
prevent
disengagement
16
from
box.
H
L
g
14
15
13
RECESS
4 Attach casing
fastener (O) with
screws (L) to
prevent
disengagement
from
16
box.
H
L
g
SINGLE LEVER CONTROL B310
cable
control
L
O
cable
control
O
L
page 11
- of 63