Maintenance; Remote Battery Installation - Napoleon NEFL42HS Manuel D'installation Et D'opération

WARNING
!
• In preparation for maintenance, always disconnect the power and allow the electric appliance to cool before
performing any cleaning, maintenance, or relocation of this electric appliance. Turn controls to off and remove
plug from outlet or turn of the house circuit breaker to electric appliance receptacle.
• Do not install replacement lamps that exceed specifi ed maximum watts.
• The halogen lamps in your appliance can be extremely hot. Allow at least 10 minutes between turning off the
appliance and removing the lamps to avoid accidental burns.
• Do not handle the lamp with bare fi ngers, oils from your skin will damage the lamps when they heat up. use
gloves or a clean dry cloth when handling lamps.
7.1

remote battery installation

WARNING
!
• This remote control requires button batteries that are hazardous to young children.
• WARNING - KEEP BATTERIES OUT OF REACH OF CHILDREN!
• Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical
burns and potential perforation of the oesophagus.
• If you suspect your child has swallowed or inserted a button battery, immediately
seek urgent medical assistance.
• Examine devices and make sure the battery compartment is correctly secured, e.g.
that the screw or other mechanical fastener is tightened. Do not use if compartment is not secure.
• Dispose of used button batteries immediately and safely. Flat batteries can still be dangerous.
• Tell others about the risk associated with button batteries and how to keep their children safe.
note:
The remote control has a removable plastic tab to prolong the battery life while shipping. Remove the tab for the
remote control to function.
1. To replace the existing battery remove the battery
holder.
2. The battery holder is equipped with a child
lock system. To remove the battery holder turn
remote onto rear side and press the left side lever
towards the center while pulling the battery holder
out using the slot provided.
3. Replace existing battery, type CR 2025, with a
new battery and reinstall the battery holder into
the remote by sliding it into position, as shown.
4. The battery holder is connected to the remote
when you hear a "CLICK".
note:
The remote control must remain within 5 meters or 17 feet of the appliance to be effective. This range may be
reduced when battery power is depleted.
Batteries must be disposed of according to the local laws and regulations. Some batteries may be
recycled, and may be accepted for disposal at your local recycling center. Check with your
municipality for recycling instructions.

7.0 maintenance

Battery (CR 2025)
Battery Holder
EN
Remote
(Rear Side)
27
W415-2005 / A / 06.26.19