Second-Curtain Sync; Flash Mode - Manual Flash; Flash Output Power Range; Optical O1 Secondary Unit Setting - Hahnel MODUS 600RT Mode D'emploi

Second-Curtain Sync

Use the < > flash setting on the camera menu to adjust
the setting of the flash light. Choose <2nd Curtain> on
the < SYNC > setting which activates the Second curtain
sync. The icon will be displayed when 2nd curtain sync
enabled

Flash Mode - Manual Flash

The flash output is adjustable from 1/1 full power to
1/128th power in 1/3rd stop increments. To obtain a
correct flash exposure, use a hand-held flash meter to
determine the required flash output.
SET
• High Speed Sync and 2nd curtain sync can be selected in
< M > mode, using the camera menu.
20
1. Press < MODE >
button so that < M > is
displayed
2. Turn the Select Dial to
choose a desired flash
output amount
3. Press < SET > button
again to confirm the
setting
Modus 600RT

Flash Output Power Range

The following table makes it easier to see how the stop
changes in terms of f/stop when you increase or decrease
the flash output.
For example, when you decrease the flash output: 1/2,
1/2-0.3, or 1/2-0.7, or increase the flash output:1/2,
1/2+0.3, 1/2+0.7, 1/1.
Figures displayed when reducing flash output level→
1/1-0.3 1/1-0.7
1/1 1/2
1/2+0.7 1/2+0.3
←Figures displayed when increasing flash output level

Optical O1 Secondary Unit Setting

In M manual flash mode, press <O1/O2> button so that
this flash can function as an optical O1 secondary flash
using its optical sensor. With this function, the flash will
fire synchronously when a second main flash fires. This is
the same effect as usng a radio trigger to fire the flash off
camera. This helps create multiple lighting effects.

Optical O2 Secondary Unit Setting

In M manual flash mode, press <O1/O2> button so that
this flash can function as an optical O2 secondary flash
using its optical sensor. With this function, the flash will
fire synchronously when a second main flash fires as in
O1 but it will ignore the metering pre-flash and fire only in
response to the exposure flash from the main unit.
• O1 and O2 optic triggering is only available in M manual
flash mode when the Modus 600 RT is off camera
• Press function button 4 <
when in 01/02 mode
Flash Mode: MULTI (Stroboscopic
Flash)
With stroboscopic flash, a rapid series of flashes is fired.
It can be used to capture multiple images of a moving
subject in a single photograph.
You can set the firing frequency (number of flashes per
sec.expressed as Hz), the number of flashes, and the
flash output power.
Modus 600RT
1/2-0.3 1/2-0.7 ------
1/4
1/4+0.7 1/4+0.3 ------
SYNC
> to activate the "HSS"
1. Press <MODE> button
so that < MULTI > is
displayed
2. Turn the Select Dial
to choose a desired flash
output power
21