SAFETY INSTRUCTIONS.-
This product is supplied with a mains
cable that has an earth wire and a plug
with an earth pin. In the event that the
appliance malfunctions then the earth
connection will redirect the electrical
current away from the machine and
reduce the risk of an electrical shock.
DANGER! If the equipment is not
earthed correctly then there is a risk of
electrical shock.
Do not modify the plug supplied with
the equipment, if it does not fit the wall
socket then get an electrician to install
an electrical socket that does.
This product must only be used on a
220-240 volt circuit, with an earthed
socket similar to that shown in Fig.A.
Always
observe
recommendations:
1
Never
use
recommended by the manufacturer.
2
Do not use the machine if the mains
cable becomes damaged or worn.
3
Keep the mains cable away from hot
surfaces.
4
Do not use the machine outdoors.
5
To unplug the machine, first put the
switch to the "0" position and then
unplug it from the wall socket.
SAFETY BREAKER.-
This model is equipped with an
electronic circuit breaker to protect both
the electronic and electrical circuits.
the
following
accessories
not
This safety device (fuse) will be
automatically triggered if the unit is
subjected to abnormal force or heat.
1.- Set switch (L), located on the
casing, to the "0" (OFF) position.
2.- Change the fuse (C) (7 Amp).
3.- Next, set switch (L) to the "I" (ON)
position and the unit will be ready for
use again. (Fig B)
ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor as shown in Fig.1.
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are there:
(4) Handlebar; (11) Vibration head;
(14) Mains cable; (16) Double strip
massage band; (16A) Massage band
with rounded ribbing; (16B) Massage
band with irregular ribbing; (17) Top
platform column; (37) Platform; (5)
Corrugated washer M-10; (6) Allen
screw M-8x55; (7) Allen screw M-
8x20; (8) Safety washer security M-8;
(9) Flat washer M-8; (12) Allen screw
M-8x15; (21) Self-locking nuts M-10;
(22) Safety washer security M-10; (23)
Flat washer M-10; (46) Allen screw M-
5x25;Box spanner; Allen key 6mm;
Allen key 5mm.
Follow these step-by-step assembly
instructions.
11
Fig B