centrifuga ***
4-03-2002
A) If your appliance comes fitted with a plug, it will incorporate
a 13 Amp fuse. If it does not fit your socket, the plug should
be cut off from the mains lead, and an appropriate plug
fitted, as below.
WARNING: Very carefully dispose of the cut off plug after
removing the fuse: do not insert in a 13 Amp socket elsewhere
in the house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit
must be protected by a 15 Amp fuse.
IMPORTANT
The wires in the mains lead are coloured in accordance with
the following code:
Blue:
Brown:
9:45
Pagina 3
Fig. 1
Fig. 4
ELECTRICAL CONNECTION (UK ONLY)
Neutral
Live
Fig. 2
If the plug is a moulded-on type, the fuse cover must be re-
fitted when changing the fuse using a 13 Amp Asta approved
fuse to BS 1362. In the event of losing the fuse cover, the
plug must NOT be used until a replacement fuse cover can
be obtained from your nearest electrical dealer. The colour of
the correct replacement fuse cover is that as marked on the
base of the plug.
B)
If your appliance is not fitted with a plug, please follow the
instructions provided below:
As the colours of the wires in the mains lead of this appliance
may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
Fig. 3
Fig. 5
3