PowerWalker VI 450 LCD Manuel De Demarrage Rapide page 7

Masquer les pouces Voir aussi pour VI 450 LCD:
Table des Matières

Publicité

NEVER connect a laser printer or scanner to the
UPS unit, because in-rush current generated by
motor's devices may cause the damage of the unit.
VI: Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again the
power switch.
6. Audible alarm from the UPS
When UPS switches from AC mode to Battery Mode to back up power supply: sounding
every 10 seconds
When battery is low: sounding every second
When UPS is overloaded: sounding every 0.5 second
When battery is faulty: sounding every 2 seconds
Other fault: Continuous sounding
7. Software Installation on your PC
Use the bundled CD and follow the on-screen instructions to install the software
ViewPower.
After the software is successfully installed, the communication with UPS has been
established and an orange icon will appear in the system tray.
Double-click the icon to use the monitor (as above).
You can schedule UPS shutdown/start-up and monitor UPS status through PC.
Detail instructions please refer to the e-manual in the software.
EN

Publicité

Table des Matières
loading

Table des Matières