Pleasant Hearth OFW750R Mode D'emploi page 5

ASSEMBLY INSTRUCTIONS
1. Insert two M6x12mm bolts (AA) through the
holes in the leg (G) and into the holes on the
side of the fire bowl (F). Secure with two M6
nuts (BB). Then, screw one M6 x 12mm bolt (AA)
through the hole on the bottom of the fire bowl
(F) and into the rivet nut in the leg (G). Repeat
these steps for the three remaining legs. Tighten
securely with a screwdriver.
Hardware Used
AA M6x12mm Bolt
BB M6 Nut
2. Attach four outer ring (D) pieces together using
four M6x12mm bolts (AA). Keep the bolts loose
during this step.
Hardware Used
AA
M6x12mm Bolt
3. Slide the assembled outer ring (D) over the
fire bowl (F) from the bottom to the top. Align the
holes on the outer ring (D) with the holes on the
fire bowl (F). Then, slide four M6x12mm bolts
(AA) through the four mesh cover rests (E) and
the holes on the inside of the fire bowl (F), then
into the holes on the outer ring (D). Secure with
four M6 nuts (BB) from the outside of the outer
ring (D). Tighten with the wrench (CC) and a
screwdriver.
Once attached to the bowl (F), tighten all bolts on
the outer ring (D) assembly.
Hardware Used
AA
M6x12mm Bolt
BB M6 Nut
CC
Wrench
1
G
x 12
x 8
2
x 4
3
x 4
D
x 4
5
AA
F
BB
AA
AA
E
BB
D
F