Scansonic Q1000 Mode D'emploi page 7

Pairing with Bluetooth Device
Bluetooth Speaker can pair with most Bluetooth 2.0 & 2.1
devices. Pairing may vary by device. Consult your Bluetooth
device's owner's manual for pairing instructions.
1. Press "Standby" key to switch to Bluetooth mode
2. Press and hold "PAIR" key for 3 seconds until consecutive
"beep" sound is played, the blue Bluetooth LED will flash,
while waiting for your Bluetooth device pairing.
3. Turn ON your Bluetooth device (e.g. Smart Phone). Go to
the Bluetooth settings, select "Scansonic Q1000" from list.
4. Connect your device to the BT Speaker with Bluetooth, your
device menu would show "Connected", the blue Bluetooth
LED is now ON, to indicate pairing success.
5. You can now play your music wirelessly with the BT
Speaker.
Remark: For mobile with Bluetooth 2.0, its request to enter pass
code during pairing, press 0000
Control the music playback
Your device must support AVRCP (Audio Video Remote Control
Profile) to control your device's playback from the Speaker.
Please check your device's owner's manual.
When the music is being played:
•
Play/Pause key
■ Press once to pause the playback
■ Press again to resume the playback
•
Vol – key
■ Press once to decrease the volume in 1 level
■ Press & Hold to decrease the volume continuously (a
"bip"sounds when the unit reaches volume min)
Q1000
7