Daisy chain :
DMX Console
Integrated terminal plug:
If no XLR connector is detected on DMX OUT connector, a 120Ω terminal plug is automatically
activated. Additional terminal plug on the last unit is not necessary.
•
Protocol: Wireless Solution W-DMX
•
Refer to the OEM User's manual for general
recommendations and use of the transmitter :
http://www.wirelessdmx.com
•
The antenna must be clearly visible from the transmitter
•
See. 4.9.2 for activation
•
Do not connect a DMX IN data cable in case of wireless
DMX use
•
In case of protocol errors, the wireless DMX is
automatically deactivated. To activate the wireless DMX
again, disconnect the DMX IN data cable, and then switch
the unit off and on.
DMX mode:
The first unit receives the DMX signal via the wireless network, then all the other units are
connected to the first one via DMX data cable
Wireless DMX option
TM
EN -7-
Maximum:
32 units
Maximum:
32 units
EN
EN
EN
EN