Making Coffee - Inventum HK 2 Mode D'emploi

5 | MAKING CoffEE

WARNING! Throw away the very first cup of coffee. It may
contain residue from the productionprocess.
take the coffeepadmachine from the base and place it on
a stable surface.
Open the lid. When you open the lid completely you will
hear a click!
take the multi-padholder out of the coffeepadmachine.
fill the coffeepadmachine slowly under the tap with
cold water. check the waterlevel in the reservoir. put, if
necessary, extra water in.
until mark = 125 ml for 1 cup
until mark = 250 ml for 2 cups or a large mug
or as much as you wish - max. 250 ml
1 cup
turn the switch on the bottom of the padholder to the
number of cups you wish to make.
For 2 cups turn the switch to the left (locked). For 1 cup
turn the switch loose to the right. An opening in the knob
will show you which position the padholder has.
2 cups
the coffeepadmachine will now heat up the water.
When it is ready, it will make the coffee.
automatically and cannot be stopped. Unless the
coffeepadmachine is taken from the base or unplugged.
ATTENTION! Pressure is build up
in the appliance. Therefore leave
the appliance to cool down completely before opening in
case of a malfunction.
As soon as the coffee making is finished, the
coffeepadmachine will automatically shut off.
Attention! Rinse the pad holder after each cup of coffee
you make before you make another cup of coffee.
In this coffeepadmachine it is also possible to use not only
the regular coffeepads, but also regular teapads. With the
multi-padholder you can also choose 1 or 2 teapads.
If you wish to make tea with this coffeepadmachine,
we advise to remove the cremamaker from the multi-
padholder and rinse the multi-padholder with warm
water. If you don't do this, you will get foam on your tea.
21
place 1 coffeepad for 1 cup with
the round side downwards in the
multi-padholder or 2 coffeepads
for 2 cups.
Do not use holders for grounded
coffee or tea.
place the multi-padholder in the
coffeepadmachine.
close the lid and lock it tight.
WarnIng! check if the lid is
properly locked. Otherwise steam
can escape through the lid.
place the coffeepadmachine on
the base and plug it into a socket.
press it on with the On-button.
the controllight will light up.
place 1 or 2 cups on the grid under
the coffee-outlet, depending on
the numbers of pads you have
placed in the multi-padholder.
This works