Kenwood KDC-MP4032 Mode D'emploi page 29

Connecting Wires to Terminals (KDC-MP332)
Rear left output (White)
Rear right output (Red)
Fuse (10A)
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier,
connect to its power control terminal.
Depending on what antenna you are using,
connect either to the control terminal of the
motor antenna, or to the power terminal for the
booster amplifier of the film-type antenna.
Connect to the terminal that is grounded
when either the telephone rings or during
conversation.
To connect the Kenwood navigation
system, consult your navigation manual.
To front right speaker
To rear right speaker
Ignition key switch
Car fuse box
(Main fuse)
Battery
+
To Kenwood disc changer/ External optional accessory
White/Black
To front left speaker
White
Gray/Black
Gray
Green/Black
To rear left speaker
Green
Purple/Black
Purple
Car fuse box
–
Front right output (Red)
Front left output (White)
FM/AM antenna input
Power control wire (Blue/White)
P.CONT
Motor antenna control wire (Blue)
ANT.
CONT
TEL mute wire (Brown)
MUTE
ACC
Ground wire (Black) - (To car chassis)
To connect these leads, refer to
the relevant instruction manuals.
Wiring harness
(Accessory1)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)
English
29
|